Amprobe ACDC-620T Clamp-On-Multimeter Uživatelský manuál stáhnout pdf (Strana 17)

Push-button Operations

The operation of the push-buttons are outlined below. When a buton is pushed,

an annunciator lights, and the unit beeps. turning the rotary switch to another

switch setting resets all push buttons to thei default states. The pushbuttons are

shown in (page15).

1. Shift / Peak ❍ :

●

This push-button is used for selecting the measurement of either

an Alternating or Direct source, Ohms or Temperature, or for selecting the

PEAK hold function.

●

Press this button momentarily to toggle DC and AC test.

or between Ω and Temperature.

●

To select PEAK hold, press and hold this button until the display shows " DH

MAX" and indicates the PEAK hold mode.

2. Hold ❍: Hold Q: DATAHOLD or Refresh Data Hold

0The data HOLD function allows operator to freeze the

displayed digital value while the analog bargraph

continues to display the present reading.

Press this button momentarily to toggle DH on or off.

The display shows "DH" to indicate the hold function.

If you select " Refresh Data Hold " by Power-ON

Options, the reading is updated to the display

automatically when the reading changes. The beeper

sounds a tone to remind user, that an update has

occurred. Press this button momentarily to toggle DH on or off.

. MAX * MIN 0: Dynamic Recording

3. MAX

●

MIN ❍: Dynamic recording

●

To enter or exit dynamic recording mode, press and hold this button to toggle

recording mmode,press and ghold this buton to toggle recording mode on or off.

●

Records maximum, minimum, and calculates tru avarage.

●

Press this button momentarily to cycle through maximum, minimum, average

and present (MAX AVGMIN) readings.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 64 65

Žádné komentáře

Amprobe ACDC-620T Clamp-On-Multimeter Uživatelský manuál Strana 17